Check out everything IDEAL has launched over the last couple of years!
CARBIDE-TIPPED HOLE CUTTERS
Ideal takes pride in creating innovative, accurate and long-lasting products so you can take pride in your work. New DEADEYE™ Carbide-Tipped Hole Cutters offer the best cost-per-cut advantage and premium features making cutting through the toughest metals simple, such as stainless steel, fast and efficient. Advanced designs including the integrated arbor, SmoothStart™ pilot bit and multi-directional carbide teeth ensure the quickest and most accurate cutting, even on aggressive materials. Built using high-quality materials and coatings including tungsten carbide teeth and DEADEYE™ Finish pilot bit for the ultimate longevity.
MAGNETIC CHIP COLLECTOR
The DEADEYE™ Magnetic Chip Collector securely attaches to magnetic surfaces and collects metal chips while cutting.
Works with up to 2-1/2” diameter cutters
Minimal profile provides improved visibility and access to workspace
Integrated keychain loop
DRILL TAPS WITH SMOOTHSTART™ TIP
Ideal added a four-piece kit, and two new individual sizes to their popular Drill Taps lineup.
Save Time: Drill, Tap and Debur in one single operation
Three-flute design
Split Point SmoothStart™ Tip
Hardened Tapping Edge
Deburring Cutting Edge
1/4 in. Hex Shank
| undefined | Part # | |
|---|---|---|
| 3/8-16 NC DRILL TAP BIT | 36-3/8-16 | |
| 5/16-18 NC Drill Tap Bit | 36-5/16-18 | |
| 4-Piece Kit | 36-601 |
IN-SURE® MC-PCS WIRE CONNECTORS
In-Sure® MC-PCS wire connector is used to splice the control and signal conductor pairs in MC-PCS cable. The outer sheath provides the required separation between power and control conductors inside of the electrical box or enclosure per 2020 NEC article 725.136.Listed as a PRESSURE-TYPE wire connector for use on the below solid and/or stranded Cu/Cu wire combinations. Consult with DAD Sales for a complete table of all CSA certified wire combinations.
Industry leading In-Sure® Push-In Wire Connector performance
Housing provides the required separation between power and control conductors
Durable latch for secure connection
Internal colors designed to match conductor insulation
20 Amp rating
Rated to organize up to eight 14/2 cables!
Used to route, fasten, and support NM, CATV, telephone, security and instrumentation cables
Organize lengthy cable runs, eliminating angled wires and excessive heating that can occur when too many cables are fastened tightly together
Angled nail allows installation from any direction
Made in Canada
Simply push in – no tools required
Protects and secures cable
Snap connectors into 1/2” or 3/4” knockouts
Securely holds cable while protecting from rough knockout edges
Quick, clean and reusable
Faster installation and 35% wider than electrical tape
Non-slip finish and exceptional elongation
Superior silicone construction
Durable for extreme temperatures
Exceeds flame retardant properties of electrical tape
Fast drying spray paint for touching up electrical panels, switchgear, and other equipment
Excellent adhesion for indoor and exterior applications
Durable, tough finish that inhibits rust
Heat resistant to 250°F
Oil and moisture resistant finish for use with electrical windings, motor frames, commutator parts, separator coils, switch bases, controller shafts, electrical insulation etc.
Excellent thread sealant for gas, oil or air lines